AED battery expiry

An AED battery sits in standby for years, then has to deliver every shock in a rescue. Its label tells you how long it has left, but makers word that label differently. Here is what each one means, and where to find it.

By the Think Health team, AED suppliers · Updated

How long AED batteries last

Most AED batteries are designed to last around four to five years in standby. Heavy use, frequent self-tests and storage somewhere very hot or cold shorten that. The label on your battery, not a rule of thumb, is what to go by.

Three kinds of battery label

  • “Install before” (Philips): the last date a new battery should be fitted. Don’t fit a spare that is past it.
  • “Replace on or before”, “install by”, or a date beside ⌛ (ZOLL, Defibtech): the date to have a new battery in by.
  • Date of manufacture (Powerheart): when the battery was made, not when it expires. Work out the replacement date from the battery life your supplier gives.

Where the battery date is, model by model

AEDWhere the battery date is
Philips HeartStart FRxOn the blue battery at the back: the “Install before” date.
Philips HeartStart HS1On the blue battery at the back: the install-before date.
ZOLL AED PlusThe “Replace batteries on or before” label, just below the status window on the handle.
ZOLL AED 3The white label on the battery at the back shows its install-by date.
Powerheart G3Lift the battery out of the bottom of the AED and read its label, then press it back until it clicks.
Powerheart G5Lift the battery out of the bottom of the AED and read its label, then press it back until it clicks.
Defibtech LifelinePress the orange eject button on the side and pull the battery out. The date is beside the ⌛ on its label. Slide it back in until it clicks.
Defibtech Lifeline AUTOPress the orange eject button on the side and pull the battery out. The date is beside the ⌛ on its label. Slide it back in until it clicks.
Defibtech Lifeline VIEWOn the same status screen: the “Battery status” line shows the expiry date.
Defibtech Lifeline ECGOn the same status screen: the “Battery status” line shows the expiry date.

Check it is fitted, too

A battery that isn’t pushed fully home can look fine and still not connect. It should sit flush with the case and click or latch into place. On the ZOLL AED Plus, which runs on ten lithium cells, the compartment cover should be closed and latched, and all ten cells are replaced together.

When to replace an AED battery

  • The date on its label has passed, or will before your next check.
  • The readiness indicator shows a fault, or the AED chirps or beeps, and a battery problem is the cause.
  • After a rescue, if the maker’s instructions say so.

After fitting a new battery, check that the readiness light shows ready again. Recycle the old one as a lithium battery, not with general waste.

Let the app read the label

Photograph the battery label and the free app reads the date, works out what it means for your model, and checks a second photo to confirm the battery is fitted. Both go in your PDF report.

Common questions

How long does an AED battery last?

Most are designed to last around four to five years in standby, less if the AED has been used a lot or kept somewhere very hot or cold. Go by your battery’s own label.

Can I recharge an AED battery?

No. AED batteries are non-rechargeable lithium packs. Never try to recharge one, and only fit the battery your AED’s maker specifies.

What does “Install before” mean on a Philips AED battery?

It is the last date a new battery should be fitted. It applies to a spare in its packaging. Once a battery is in the AED, the AED’s own self-tests keep watch on it.

How do I know my AED battery is low?

The readiness indicator stops showing ready, and many AEDs chirp or beep. That is why the monthly check starts with the readiness light.